Panasonic SDR-H280 SDRH280 User Manual

Product codes
SDRH280
Page of 112
19
LSQT1363
Setup
Setup
Power supply
When this unit is purchased, the battery is not 
charged. Charge the battery before using this 
unit.
≥ If the DC cable is connected to the AC 
adaptor, then the battery will not be 
charged. Remove the DC cable from the AC 
adaptor.
1
Connect the AC cable to the AC 
adaptor and the AC outlet.
2
Put the battery on the battery 
mount by aligning the mark, and 
then securely plug it in.
≥ The output plug of the AC cable is not 
completely connected to the AC adaptor 
socket. As shown in A, there is a gap.
∫ Charging lamp
≥ Battery charging time (
l 20)
≥ We recommend using Panasonic batteries. 
(l 10)
≥ If you use other batteries, we cannot guarantee 
the quality of this product.
Push the battery against the battery 
holder and slide it until it clicks.
While sliding the BATTERY lever, 
slide the battery to remove it.
≥ Hold the battery with your hand so it does not 
fall.
≥ Before removing the battery, be sure to set the 
OFF/ON switch to OFF and check that the 
status indicator is off.
It has been found that counterfeit battery 
packs which look very similar to genuine 
product are made available to purchase in 
some markets. Some of these battery packs 
are not adequately protected with internal 
protection to meet the requirements of 
appropriate safety standards. There is a 
possibility that these battery packs may lead 
to fire or explosion. Please be advised that we 
are not liable for any accident or failure 
occurring as a result of use of a counterfeit 
battery pack. To ensure that safe products are 
used we would recommend that the genuine 
Panasonic battery pack is used.
≥ Be aware that many batteries sold at 
extremely cheap prices or in situations where 
it is difficult to verify the actual products before 
purchase have proven to be counterfeit.
Charging the battery
A
Lights up: Charging
Goes off:
Charging completed
Flashing:
The battery is over discharged 
(discharged excessively). In a while, 
the lamp will light up and normal 
charging will start.
When the battery temperature is 
excessively high or low, the CHARGE 
lamp flashes and the charging time will 
be longer than normal.
Inserting the battery
Removing the battery
Body1_mst.fm  19 ページ  2008年2月8日 金曜日 午後4時35分