Manualsbrain.com
  1. Manuals
  2. Brands
  3. Thecus
  4. 2.5TB Network Storage Black
  5. Leaflet

Thecus 2.5TB Network Storage Black N5200BR_5050 Leaflet

Product codes
N5200BR_5050
Download
Page of 90
RAID 
Current RAID status. 
System Fan 
Current system fan status. 
CPU Fan 
Current CPU fan status 
2006/06/16 12:00 
Current system time. 
 
The N5200 will rotate these messages every one-two seconds on the LCD display. 
USB Copy 
The USB Copy function enables you to copy files stored on USB devices such as 
USB disks and digital cameras to the N5200 with a press of a button. To use USB 
copy, follow the steps below: 
 
1.  Plug your USB device into an available USB port on the Front Panel. 
 
2.  In Display Mode, press the Down Button (▼). 
 
3.  The LCD will display “USB Copy?”  
 
4.  Press Enter (
↵
) and the N5200 will start copying USB disks connected to 
the front USB port. 
 
5.  All of data will be copied into system folder named “USBcopy”.  
Management Mode 
During setup and configuration, the LCD will be in Management Mode. 
 
To enter into Management Mode, press Enter (
↵)
 and an “Enter Password” 
prompt will show on the LCD. 
 
At this time, the administrator has to enter the correct LCD password. System will 
check whether the correct LCD password has been entered. The default LCD 
password is “0000”. If correct password is entered, you will enter into the 
Management Mode menu. 
 
Management Mode 
Item Description 
WAN Setting 
IP address and netmask of your WAN ports. 
LAN Setting 
IP address and netmask of your LAN ports. 
Link Agg. Setting 
Select Load Balance or Failover. (N5200B only) 
Change Admin Passwd  Change administrator’s password for LCD operation. 
Reset to Default 
Reset system to factory defaults. 
Exit Exit 
Management Mode and return to Display Mode. 
 
NOTE 
You can also change your LCD password using the Web Administration 
Interface by navigating to System > Administrator Password. For 
more on the Web Administration Interface, see Chapter 4: System 
Management. 
 
 
Typical Setup Procedure 
From the Web Administration Interface, you can begin to setup your N5200 for 
use on your network. Setting up the N5200 typically follows the five steps 
outlined below. 
 
For more on how to use the Web Administration Interface, see Chapter 4: 
System Management > 
 
 
 
19