Thecus 2.5TB Network Storage Black N5200BR_5050 Leaflet

 

 
 

72 

b.  You should see the login page of N5200. 

If you are using a software firewall (i.e. Norton Internet Security) and are having 

trouble connecting to the N5200, you can try the following steps: 
 

1.  Double click the NIS icon on system tray, and then configure the 

Personal Firewall. 

 

2.  On the Programs page, find the SetupWizard.exe and change its 

permission to "Permit All". If it's not in the program list, use the Add or 

Program Scan buttons to find it. 

 

3.  On the Networking page, manually add N5200 IP address (i.e. 

192.168.1.100

) to the Trusted list.  

 

If you are using RAID 1, RAID 5, RAID 6, or RAID 10, you can easily replace a 
damaged hard drive in the Thecus N5200 while keeping your data secure with the 
system’s automatic data recovery.  

When a hard drive is damaged and data in the RAID volume, the system LCD will 
display warning message also the system beeps. 

To replace a hard disk drive in the N5200: 
 

1.  Remove the tray with the damaged hard disk. 
2.  Unscrew the damaged hard disk and remove it from the tray. 

 

3.  Slide a new hard disk into the tray and fasten the screws. 

 

4.  Insert the hard disk tray back into the N5200 until it snaps into place. You 

can also lock it with a key if desired. 

 

5.  The LED blinks green when the HDD is accessed. 

When using RAID 1, 5, 6, or 10 on the N5200, you can use the auto-rebuild 
function when an error is detected.  

 

1.  When a hard disk fails the system beeps and/or an email notification is 

sent to specified receivers. 

 
2.  Check the LCD to see which disk has failed. 

 

3.  Follow the steps mentioned above to replace the failed hard disk. 

 

4.  The system automatically recognizes the new hard disk and starts the 

auto-rebuild sequence to resume its status before the hard disk crash.