Thecus 2.5TB N5200 BR PRO Network Storage N5200BRPRO_5050 Leaflet

 

 
 

13 

Your N5200PRO is designed for easy installation. To help you get started, the 
following chapter will help you quickly get your N5200PRO up and running. Please 

read it carefully to prevent damaging your unit during installation. 

Before you begin, be sure to take the following precautions: 

 

1.  Read and understand the Safety Warnings outlined in the beginning of 

the manual. 

 

2.  If possible, wear an anti-static wrist strap during installation to prevent 

static discharge from damaging the sensitive electronic components on the 
N5200PRO. 

 

3.  Be careful not to use magnetized screwdrivers around the N5200PRO’s 

electronic components. 

The N5200PRO supports five standard 3.5” Serial ATA (SATA) hard disks. To 
install a hard disk into the N5200PRO, follow the steps below: 

 

1.  Remove a hard disk tray from the N5200PRO. 

 

2.  Slide the new SATA hard disk into the tray and fasten the screws. 

 

3.  Insert the hard disk and tray back into the N5200PRO until it snaps into 

place and lock it with a key if desired. 

 

4.  The LED blinks green when the hard disk is accessed.  

 
 
 

 

If your HDD was part of a RAID 1 or RAID 5 array previously, it 

automatically rebuilds. If you replace all the drives with higher capacity 

drives, you will need to go to Administrator login and format the drives.