Thecus 5TB Network Storage Black N5200BR_5100 Leaflet

Your N5200 is designed for easy installation. To help you get started, the 
following chapter will help you quickly get your N5200 up and running. Please 

read it carefully to prevent damaging your unit during installation. 

Before you begin, be sure to take the following precautions: 

 

1.  Read and understand the Safety Warnings outlined in the beginning of 

the manual. 

 

2.  If possible, wear an anti-static wrist strap during installation to prevent 

static discharge from damaging the sensitive electronic components on the 
N5200. 

 

3.  Be careful not to use magnetized screwdrivers around the N5200’s 

electronic components. 

The N5200 supports five standard 3.5” Serial ATA (SATA) hard disks. To install a 
hard disk into the N5200, follow the steps below: 

 

1.  Remove a hard disk tray from the N5200. 
 

2.  Slide the new SATA hard disk into the tray and fasten the screws. 

 

3.  Insert the hard disk and tray back into the N5200 until it snaps into place 

and lock it with a key if desired. 

 

4.  The LED blinks green when the hard disk is accessed.  

 

If your HDD was part of a RAID 1 or RAID 5 array previously, it 
automatically rebuilds. If you replace all the drives with higher capacity 

drives, you will need to go to Administrator login and format the drives. 

 
 

 

 

 
 

13