Gigaset SL56 HANDGIGASL56 User Manual
Product codes
HANDGIGASL56
50
Appendix
Gigaset SL560 / GBR PTT / A31008-M1710-L111-2-7619 / appendix.fm / 12.6.07
Appendix
Care
Wipe the base station, charging cradle and
handset with a damp cloth (do not use
solvent) or an antistatic cloth.
Never use a dry cloth. This can cause
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch off the handset and remove
1. Switch off the handset and remove
the battery pack immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any queries about the use of
your telephone, you can contact us at any
time at
The table below contains a list of common
problems and possible solutions.
!
The display is blank.
1. The handset is not switched on.
1. The handset is not switched on.
¥
Press and hold the end call key
a
.
2. The battery pack is flat.
¥
Charge/replace the battery pack
The handset does not respond to a key press.
The keypad lock is activated.
The keypad lock is activated.
¥
Press and hold the hash key
#
"Base station x" is flashing in the display.
1. The handset is outside the range of the base
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
The base station's range is reduced because
eco mode is activated.
¥
Deactivate eco mode (page 16) or
reduce the distance between the hand-
set and the base station.
2. The handset has been de-registered.
¥
Register the handset (page 34).
3. The base station is not switched on.
¥
Check the base station mains adapter
Base Search is flashing in the display.
The handset is set for
The handset is set for
Best Base
and no base sta-
tion is switched on or within range.
¥
Reduce the distance between handset/base
station.
¥
Check the base station mains adapter
Handset does not ring.
1. The ringtone is switched off.
1. The ringtone is switched off.
¥
Activate the ringtone (page 40).
2. Call diversion set to
All Calls
.
¥
Switch off Call Diversion (page 17).