Thecus 1TB 1-bay NAS N199_1100 Leaflet
Product codes
N199_1100
RAID Auto-Rebuild
When using RAID 1 on the N199, you can use the auto-rebuild function when an
error is detected.
error is detected.
1. When a hard disk fails the system beeps and/or an email notification is
sent to specified receivers.
2. Check the hard disk LEDs to see which disk has failed.
3. Follow the steps mentioned above to replace the failed hard disk.
4. The system automatically recognizes the new hard disk and starts the
auto-rebuild sequence to resume its status before the hard disk crash.
Remote Administration
You can set up your N199 for remote administration. With remote administration,
you can access your N199 over the Internet, even if your N199 is behind a router.
This is especially useful if you are traveling and suddenly need a file from your
This is especially useful if you are traveling and suddenly need a file from your
N199.
Setting up remote administration is a three-part process, and will require the
following equipment:
following equipment:
•
Thecus N199 NAS device
•
Cable/DSL Router with Dynamic DNS support
•
Home PC
•
Internet Connection
NOTE
Router setup will differ slightly depending on router used. For this example, we will
use the Asus WL500g because it has support for Dynamic DNS. Contact your router
hardware vendor for setup help.
Part I - Setup a DynDNS Account
1. Go to http://www.dyndns.org from your home PC.
2. Click on the Sign Up Now link.
3. Check the Check boxes, select a user name (i.e.: N199), enter your email
2. Click on the Sign Up Now link.
3. Check the Check boxes, select a user name (i.e.: N199), enter your email
address (i.e.: xxx@example.com), check Enable Wildcard, and create a
password (i.e.: xxxx).
password (i.e.: xxxx).
4. Wait for an email from www.dyndns.org.
5. Open the email and click on the link to activate your account
5. Open the email and click on the link to activate your account
Part II - Enable DDNS on the Router
1. Go to the router setup screen and select IP Config > Miscellaneous
DDNS Setting from your Home PC.
2. Click on Yes for Enable the DDNS Client?
3. Select www.dyndns.org.
4. Go to router setup screen, and enter the following information:
3. Select www.dyndns.org.
4. Go to router setup screen, and enter the following information:
a. User Name or E-mail Address: xxx@example.com
b. Password or DDNS Key: xxxx
b. Password or DDNS Key: xxxx
c. Host Name: www.N199.dyndns.org
d. Enable wildcard? Select Yes
d. Enable wildcard? Select Yes
e. Update Manually: Click Update
79