Gw Instek PEL-3211 Electronic Load PEL-3211 Data Sheet
Product codes
PEL-3211
PEL-3000 User Manual
112
Data Edit
Overview
Overview
Each step in a fast sequence contains the
following setting parameters:
following setting parameters:
Setting
Setting Range
Description
Step
0001 ~ 1000
Selects/displays the current
step in the sequence.
step in the sequence.
The number of available
steps is dependent on the
number of steps added using
the Ins. Point[F1] functions.
steps is dependent on the
number of steps added using
the Ins. Point[F1] functions.
A minimum of 3 steps.
Value
The current or resistance
setting for the selected
operating mode.
setting for the selected
operating mode.
TRIG OUT
ON, OFF
When TRIG OUT is set to
ON, a trigger signal is
output from the TRIG OUT
BNC terminal at the start of
the step. See page 150 for
details.
ON, a trigger signal is
output from the TRIG OUT
BNC terminal at the start of
the step. See page 150 for
details.
Time
amplitude
TRIG OUT = ON
TRIG OUT
Start of step
FILL Overview
The FILL function is used to evenly step up the
current or resistance value settings from a
starting step to a finishing step.
current or resistance value settings from a
starting step to a finishing step.
The Fill Function can be used before or after
points are added to the fast sequence.
points are added to the fast sequence.
Before: Will pre-fill each value within the fill
range when a new step is added.
range when a new step is added.
After: Will post-fill each value within the fill