Fluke ScopeMeter 125/001 2- Channel hand-held oscilloscope, Scope-Meter, hand-heldBandwidth 40 MHz 2838888 User Manual
Product codes
2838888
Fluke 125
Users Manual
Users Manual
0-4
Safely Using the Test Tool
Attention
Carefully read the following safety
information before using the test tool.
information before using the test tool.
Safety Precautions
Specific warning and caution statements, where they
apply, will be found throughout the manual.
A Caution identifies conditions and actions that may
damage the test tool.
damage the test tool.
A Warning identifies conditions and actions that pose
hazard(s) to the user.
hazard(s) to the user.
Symbols used on the test tool and in this manual are
explained in the next table.
Warning
To avoid electrical shock, use only Fluke power
supply, Model PM8907 (Power Adapter/Battery
Charger).
supply, Model PM8907 (Power Adapter/Battery
Charger).
See explanation in
manual
manual
Equal potential inputs
Disposal information
Earth
Recycling information
Conformité
Européenne
Européenne
Double Insulation
(Protection Class)
(Protection Class)
Conforms to
applicable Canadian
and US standards
applicable Canadian
and US standards
Do no dispose of this product as unsorted municipal
waste. Go to Fluke's website for recycling information.
waste. Go to Fluke's website for recycling information.
Warning
Should this test tool be used with AC coupling
selected, or manual operation of amplitude or time
base ranges, the measuring results displayed on
the screen may not be representative of the total
signal. This can result in the presence of
dangerous voltages of more than 42V peak (30V
rms), not being detected. To guarantee user safety,
all signals should first be measured with DC
coupling selected and in fully automatic mode.
This ensures that the full signal content is
measured.
selected, or manual operation of amplitude or time
base ranges, the measuring results displayed on
the screen may not be representative of the total
signal. This can result in the presence of
dangerous voltages of more than 42V peak (30V
rms), not being detected. To guarantee user safety,
all signals should first be measured with DC
coupling selected and in fully automatic mode.
This ensures that the full signal content is
measured.