Fluke Calibrator, 4353229 Data Sheet

42 

There are three modes of operation of the Product: Local, 
Remote, and Remote with Lockout. Local mode is the 
default mode. Commands may be entered with the 
keypad on the Product or with a computer. In Remote 
mode the keypad is disabled and commands may only be 
entered with a computer. If [GO TO LOCAL] is chosen 
from the display menu, the Product restores keypad 
operation. In Remote with Lockout, the keypad cannot be 
used.  

To switch modes: 

1.  To enable Remote mode, enter the serial command 

REMOTE at the computer terminal. 

2.  To enable Remote with Lockout, enter “REMOTE 

LOCKOUT” in either order. 

3.  To switch back to local operation enter LOCAL at the 

terminal. This command also turns off LOCKOUT if it 
is on. For more information on commands, refer to 
the “Remote Commands” section. 

Refer to the “Remote Commands” section for all available 
commands. The Product may be controlled by commands 
and queries. All commands may be entered with upper or 
lower case. The commands are divided into the 
categories listed below: 

Only the Product uses these commands. For example: 

VAL? 

asks for the values displayed on the Product display. 

Standard commands used by most devices. These 
commands always begin with an “*”. 

For example: 

*IDN? 

tells the Product to return its identification.