Gigaset E45 S30852-H1751-B103 User Manual

Gigaset E45 / English / A31008-M1751-R201-1-SM19 / start_guide_time.fm / 04.08.2005

¤

Wipe the charging cradle and the hand-

set with a damp cloth (do not use sol-

vent) or an antistatic cloth. 

Never use a dry cloth. This can cause 

static. 

Your handset is splash proof. 
If it comes into contact with water, knock 

the water out of the microphone opening 

and remove any water on the handset 

with an absorbent cloth. Your handset is 

ready for use. 
If your handset comes into contact with a 

larger amount of liquid take the following 

steps: 
1. Do not switch the handset on under 

any circumstances! 

2. Remove the battery pack immediately. 
3. Remove the headset socket cover. 
4. Hold the handset horizontally with the 

open battery compartment facing 

down.

5. Hold the handset vertically. Tilt the 

handset backwards and forwards 

slightly, giving it a gentle shake each 

time.

6. Dab all parts dry and then leave the 

handset for at least 72 hours with the 

battery compartment open and the 

keypad facing down in a dry, warm 

place (not: microwave, oven or similar).

When it has fully dried out, you will nor-

mally be able to use it again. 

If you have any queries about the use of 

your telephone, you can contact us at any 

time at www.siemens.com/gigasetcus-

tomercare . The table below contains a list 

of common problems and possible solu-

tions.

The display is blank. 
1. The handset is not switched on.

¥

Press and hold the end call key 

a

.

2. The battery pack is flat.

¥

Charge/replace the battery pack 

The handset does not respond to a key press. 
The keypad lock is activated.

¥

Press and hold the hash key 

#

 

 "Base station x" is flashing in the display.
1. The handset is outside the range of the base 

station.

¥

Reduce the distance between handset/

base station.

2. The handset has been de-registered.

¥

Register the handset (page 5).

Base Search is flashing in the display. 
Handset is set for 

 and no base station 

is within range.

¥

Reduce the distance between handset/base 

station.

Handset does not ring. 
The ringtone is switched off.

¥

Activate the ringtone (page 16).

The other party cannot hear you. 
You have pressed the 

u

 (INT) key. The hand-

set is "muted".

¥

Switch on the microphone again (page 8).

You hear an error tone when keying an input 
(a descending sequence of tones).
Action has failed/invalid input. 

¥

Repeat the operation. 
Watch the display and refer to the operating 

instructions if necessary.