Garrett Metal detector GTI 2500 Pro Package Metal Detector 98949 GTI 2500 Pro 98949 Data Sheet

 
 
 

 

 
1.  Compress the button ends of the spring clip and insert, button end first, into the lower stem 

of the detector so that the button ends pop out of the holes. The spring clip is installed at 
the factory in the upper metal stem. This will enable the stem assembly to be attached to 
the electronic housing and the over all length of the detector adjusted for a comfortable 
operating length. 

2.  Attach the lower stem to the searchcoil by inserting the two rubber washers into the stem 

and slipping the searchcoil onto the stem. Insert the threaded bolt through the holes and 
hand-tighten the two knobs. 

3.  Install the upper stem to the lower and then this assembly to the detector housing by 

depressing the buttons and coupling the stem to the housing. Adjust for the most 
comfortable operating length. 

4.  Wrap the searchcoil cable snugly about the stem with the first turn of the cable over the 

stem. 

5.  Insert the cable connector into the connector on the detector housing and hand-tighten 

securely. 

 
 

 
Familiarize yourself with the touchpad controls.  Their basic functions are given here.  How 
they can help you find treasure is explained in the Operating Instructions of this Manual. 
 
Power/ Hold to reset: 
•  Turns the detector on; 

•  Turns the detector off; 

•  Returns the detector to factory settings. 
 
Raise searchcoil approximately one foot above the ground.  Press the touchpad once, and the 
detector begins operating.  Each time the detector is turned on, the battery condition is 
reported on the detector's LCD Display and the detector automatically begins operating in the 
Discriminate Coins mode.  
Press once again to turn the detector off.  Special memory circuitry will retain all settings 
made. Also, the detector will switch itself off automatically when no touchpad is pushed and no 
target is detected during a period of 10 minutes 
 
Menu/Scroll: