Timex Ironman Run Trainer 2.0 GPS Technologie Strapless GPS heart rate monitor watch T5K745 Data Sheet

If you can’t get a GPS fix, try these steps:

•   Make sure that you are outside. It can be very difficult to acquire a fix indoors.

•   Move away from buildings and tall trees. Large structures can block the satellite signals.

•   Stand still. Movement can increase the time it takes for the GPS to acquire a satellite signal.

noTe: While the first GPS fix can take some time to acquire, obtaining subsequent fixes is usually faster as the 

GPS searches for recently acquired satellites first. 

If you can’t get heart rate data from the sensor, try these steps:

•   Make sure heart rate sensor is on and is fitted correctly. Poor placement can keep the heart rate sensor

from obtaining a reading. See 

. 

•   Use the SENSORS menu to search for the heart rate sensor. There may have been a problem with the 

previous pairing operation. See 

. 

•   Install a fresh battery in the heart rate sensor. A low battery can make the heart rate sensor signal weak

or nonexistent. 

•   Use the SENSORS menu to search for the foot pod. There may have been a problem with the previous 

pairing operation. See 

•   Install a fresh battery in the foot pod. A low battery can make the foot pod signal weak or nonexistent.

•   Make sure the metal teeth on the charging clip line up with the metal discs on the back of the watch,

and that the charging cable is plugged in to the USB port on the computer. Firm connections are essen-

tial to communication between the watch and the computer. 

•   Make sure the Device Agent is open in the computer. All communication between the watch and the

computer is managed by the Device Agent. 

•   Make sure you have selected the Run Trainer

™

 2.0 in the Device Agent. The Device Agent must be set to 

establish a connection with a specific device type.  

•   If all of these conditions are met, but the Device Agent does not show the watch as connected, leave the

charging clip attached to the watch and unplug the USB end of the charging cable from the computer. 

Then, reconnect the charging cable to the USB port on the computer. 

The Run Trainer

™

 2.0 GPS is water resistant to 50 meters. 

WaRnInG: To maintain water resistance, do not press any buttons under water. 

•   Watch is water-resistant only as long as lens, push buttons, and case remain intact.

•   Watch is not a dive watch and should not be used for diving.

•   Rinse watch with fresh water after exposure to salt water.

Water-Resistance Depth

p.s.i.a. *Water Pressure Below Surface

*pounds per square inch absolute