Medisana CardioCompact 51098 User Manual
Product codes
51098
3 Getting started
GB
28
Please note that the date and time will have to be reset each time
new batteries are inserted.
new batteries are inserted.
WARNING
BATTERY SAFETY INFORMATION
• Do not disassemble batteries!
• Remove discharged batteries from the device
immediately!
• Increased risk of leakage, avoid contact with skin,
eyes and mucous membranes! If battery acid
comes in contact with any of this parts, rinse the
affected area with copious amounts of fresh water
and seek medical attention immediately!
comes in contact with any of this parts, rinse the
affected area with copious amounts of fresh water
and seek medical attention immediately!
• If a battery has been swallowed seek medical
attention immediately!
• Replace all of the batteries simultaneously!
• Only replace with batteries of the same type,
never use different types of batteries together or
used batteries with new ones!
used batteries with new ones!
• Insert the batteries correctly - observe the polarity!
• Keep the battery compartment well sealed!
• Remove the batteries from the device if it is not
going to be used for an extended period!
• Keep batteries out of children’s reach!
• Do not attempt to recharge these batteries!
There is a danger of explosion!
• Do not short circuit! Danger of explosion!
• Do not throw into a fire! Danger of explosion!
• Do not throw used batteries into the household
refuse; put them in a hazardous waste container or
take them to a battery collection point, at the shop
where they were purchased!
take them to a battery collection point, at the shop
where they were purchased!
3.2 Using a mains adaptor
Alternatively, you can use the unit with a special mains adaptor (6V/
600mA, MEDISANA Art.-No. 51095). This connects to the socket
4
provided at the side of the unit. Before connecting, adjust the
display tilt angle in that way, that the marking of the tilt mechanism
3
indicates “OFF”. In this case the batteries remain in the unit.
Inserting the connector into the side of the blood pressure monitor
switches the batteries off mechanically. It is necessary, therefore,
switches the batteries off mechanically. It is necessary, therefore,
to plug the mains adaptor into the mains socket first of all and then
to connect it to the blood pressure monitor. If the blood pressure
to connect it to the blood pressure monitor. If the blood pressure
monitor is no longer being used, first remove the connector from the
blood pressure monitor and then pull the mains adaptor out of the
mains socket. Doing this means that the date and time will not have
to be reset each time.
blood pressure monitor and then pull the mains adaptor out of the
mains socket. Doing this means that the date and time will not have
to be reset each time.
51098 Travel GA West AM Master.indd 36
27.09.2012 12:29:18