Atmel MCU Evaluation Kit AT32UC3L-EK AT32UC3L-EK Data Sheet
Product codes
AT32UC3L-EK
8
Atmel AVR32025
32150B-AVR-03/12
“3.3V Single Supply Mode,” in section 6.1.3.1 in the
schematics of this mode: this is how it is implemented on this board.
3.1.3.2 Atmel AT32UC3L064 pinout for the power supply block
Table 3-1. The Atmel AVR UC3L pinout for the power supply block.
QFP48 pin
GPIO
GPIO alternate functions
Feature
1 N.A.
N.A.
GND
4 PA03
GPIO[3]
The Power-Off signal from the
AT32UC3L064 to the power supply
block
AT32UC3L064 to the power supply
block
17 N.A.
N.A.
VDDIN
18 N.A.
N.A.
VDDCORE
19 N.A.
N.A.
GND
33 N.A.
N.A.
GNDANA
34 N.A.
N.A.
ADVREFP
35 N.A.
N.A.
VDDANA
42 N.A.
N.A.
VDDIO
48 N.A.
N.A.
VDDIO
3.1.4 Configurations and test points
3.1.4.1 Hardware configurations
The default hardware configuration of the power supply block implies that:
• The power supply sources are the battery or the USB plug (thus the dotted-lines
on the J2 plug in the block diagram, cf.
)
• The power-off signal from the AT32UC3L064 is not connected to the on-board
power supply block (thus the dotted arrow in the block diagram)
To enable the power supply through the J2 connector, mount the R5 resistor (solder
patch) and remove the R6 resistor.
patch) and remove the R6 resistor.
To activate the Power-Off signal, remove the R17 resistor and mount the R26 resistor
(solder patch).
(solder patch).
To locate the resistors mentioned here above, use the assembly top/bottom views
provided in Section
provided in Section
,