Atmel SAM4S Xplained Pro Starter and Evaluation Kit ATSAM4S-XPRO ATSAM4S-XPRO Data Sheet
Product codes
ATSAM4S-XPRO
SAM4S Series [DATASHEET]
Atmel-11100G-ATARM-SAM4S-Datasheet_27-May-14
468
26.13.2 Switching from (to) Slow Clock Mode to (from) Normal Mode
When switching from slow clock mode to the normal mode, the current slow clock mode transfer is completed at
. The external device
may not be fast enough to support such timings.
illustrates the recommended procedure to properly switch from one mode to the other.
Figure 26-29. Clock Rate Transition Occurs while the SMC is Performing a Write Operation
Figure 26-30. Recommended Procedure to Switch from Slow Clock Mode to Normal Mode or from Normal Mode to Slow Clock
Mode
A[23:0]
NCS
1
MCK
NWE
1
1
NWE_CYCLE = 3
SLOW CLOCK MODE WRITE
Slow Clock Mode
internal signal from PMC
1
1
1
2
3
2
NWE_CYCLE = 7
NORMAL MODE WRITE
Slow clock mode
transition is detected:
Reload Configuration Wait State
This write cycle finishes with the slow clock mode set
of parameters after the clock rate transition
SLOW CLOCK MODE WRITE
A[23:0]
NCS
1
MCK
NWE
1
1
SLOW CLOCK MODE WRITE
Slow Clock Mode
internal signal from PMC
2
3
2
NORMAL MODE WRITE
IDLE STATE
Reload Configuration
Wait State