Atmel Evaluation Kit AT91SAM9X35-EK AT91SAM9X35-EK Data Sheet
Product codes
AT91SAM9X35-EK
388
SAM9X35 [DATASHEET]
11055E–ATARM–10-Mar-2014
29.13.2 Switching from (to) Slow Clock Mode to (from) Normal Mode
When switching from slow clock mode to the normal mode, the current slow clock mode transfer is completed at high
clock rate, with the set of slow clock mode parameters.See
clock rate, with the set of slow clock mode parameters.See
. The external device may not be
fast enough to support such timings.
illustrates the recommended procedure to properly switch from one mode to the other.
Figure 29-32.Clock Rate Transition Occurs while the SMC is Performing a Write Operation
A
[25:2]
NCS
1
MCK
NWE
1
1
NWE_CYCLE = 3
SLOW CLOCK MODE WRITE
Slow Clock Mode
internal signal from PMC
1
1
1
2
3
2
NWE_CYCLE = 7
NORMAL MODE WRITE
Slow clock mode transition is detected:
Reload Configuration Wait State
This write cycle finishes with the slow clock mode set
of parameters after the clock rate transition
SLOW CLOCK MODE WRITE
NBS0, NBS1,
NBS2, NBS3,
A0,A1
NBS2, NBS3,
A0,A1