Atmel Evaluation Kit AT91SAM9X35-EK AT91SAM9X35-EK Data Sheet

391

SAM9X35 [DATASHEET]

11055E–ATARM–10-Mar-2014

The Byte Access Type configuration remains active in page mode. For 16-bit or 32-bit page mode devices that require
byte selection signals, configure the BAT field of the SMC_REGISTER to 0 (byte select access type).

The page mode is not compatible with the use of the NWAIT signal. Using the page mode and the NWAIT signal may
lead to unpredictable behavior.

If the chip select and the MSB of addresses as defined in 

 are identical, then the current access lies in the

same page as the previous one, and no page break occurs. 

Using this information, all data within the same page, sequential or not sequential, are accessed with a minimum access
time (t

sa

). 

 illustrates access to an 8-bit memory device in page mode, with 8-byte pages. Access to D1

causes a page access with a long access time (t

pa

). Accesses to D3 and D7, though they are not sequential accesses,

only require a short access time (t

sa

).

If the MSB of addresses are different, the SMC performs the access of a new page. In the same way, if the chip select is
different from the previous access, a page break occurs. If two sequential accesses are made to the page mode memory,
but separated by an other internal or external peripheral access, a page break occurs on the second access because the
chip select of the device was deasserted between both accesses.

A

[25:3]

A[2], A1, A0

NCS

MCK

NRD

Page address

A1

A3

A7

D[7:0]

NCS_RD_PULSE

NRD_PULSE

NRD_PULSE

D1

D3

D7