Atmel Xplained Pro Evaluation Kit ATSAM4E-XPRO ATSAM4E-XPRO Data Sheet
Product codes
ATSAM4E-XPRO
SAM4E [DATASHEET]
Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14
538
28.8.6 Coding Timing Parameters
All timing parameters are defined for one chip select and are grouped together in one SMC_REGISTER according
to their type.
to their type.
The SMC_SETUP register groups the definition of all setup parameters:
NRD_SETUP, NCS_RD_SETUP, NWE_SETUP, NCS_WR_SETUP
The SMC_PULSE register groups the definition of all pulse parameters:
NRD_PULSE, NCS_RD_PULSE, NWE_PULSE, NCS_WR_PULSE
The SMC_CYCLE register groups the definition of all cycle parameters:
NRD_CYCLE, NWE_CYCLE
shows how the timing parameters are coded and their permitted range.
28.8.7 Reset Values of Timing Parameters
gives the default value of timing parameters at reset.
28.8.8 Usage Restriction
The SMC does not check the validity of the user-programmed parameters. If the sum of SETUP and PULSE
parameters is larger than the corresponding CYCLE parameter, this leads to unpredictable behavior of the SMC.
parameters is larger than the corresponding CYCLE parameter, this leads to unpredictable behavior of the SMC.
For read operations:
Null but positive setup and hold of address and NRD and/or NCS can not be guaranteed at the memory interface
because of the propagation delay of theses signals through external logic and pads. If positive setup and hold
values must be verified, then it is strictly recommended to program non-null values so as to cover possible skews
between address, NCS and NRD signals.
because of the propagation delay of theses signals through external logic and pads. If positive setup and hold
values must be verified, then it is strictly recommended to program non-null values so as to cover possible skews
between address, NCS and NRD signals.
Table 28-2.
Coding and Range of Timing Parameters
Coded Value
Number of Bits
Effective Value
Permitted Range
Coded Value
Effective Value
setup [5:0]
6
128 x setup[5] + setup[4:0]
0
≤ ≤ 31
0
≤ ≤ 128+31
pulse [6:0]
7
256 x pulse[6] + pulse[5:0]
0
≤ ≤ 63
0
≤ ≤ 256+63
cycle [8:0]
9
256 x cycle[8:7] + cycle[6:0]
0
≤ ≤ 127
0
≤ ≤ 256+127
0
≤ ≤ 512+127
0
≤ ≤ 768+127
Table 28-3.
Reset Values of Timing Parameters
Register
Reset Value
SMC_SETUP
0x01010101
All setup timings are set to 1
SMC_PULSE
0x01010101
All pulse timings are set to 1
SMC_CYCLE
0x00030003
The read and write operation last 3 Master Clock
cycles and provide one hold cycle
cycles and provide one hold cycle
WRITE_MODE
1
Write is controlled with NWE
READ_MODE
1
Read is controlled with NRD