Atmel Xplained Pro Evaluation Kit ATSAM4E-XPRO ATSAM4E-XPRO Data Sheet
Product codes
ATSAM4E-XPRO
SAM4E [DATASHEET]
Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14
542
Figure 28-16. Early Read Wait State: NWE-controlled Write with No Hold Followed by a Read with one Set-up Cycle
28.10.3 Reload User Configuration Wait State
The user may change any of the configuration parameters by writing the SMC user interface.
When detecting that a new user configuration has been written in the user interface, the SMC inserts a wait state
before starting the next access. The so called “Reload User Configuration Wait State” is used by the SMC to load
the new set of parameters to apply to next accesses.
before starting the next access. The so called “Reload User Configuration Wait State” is used by the SMC to load
the new set of parameters to apply to next accesses.
The Reload Configuration Wait State is not applied in addition to the Chip Select Wait State. If accesses before
and after re-programming the user interface are made to different devices (Chip Selects), then one single Chip
Select Wait State is applied.
and after re-programming the user interface are made to different devices (Chip Selects), then one single Chip
Select Wait State is applied.
On the other hand, if accesses before and after writing the user interface are made to the same device, a Reload
Configuration Wait State is inserted, even if the change does not concern the current Chip Select.
Configuration Wait State is inserted, even if the change does not concern the current Chip Select.
28.10.3.1User Procedure
To insert a Reload Configuration Wait State, the SMC detects a write access to any SMC_MODE register of the
user interface. If the user only modifies timing registers (SMC_SETUP, SMC_PULSE, SMC_CYCLE registers) in
the user interface, he must validate the modification by writing the SMC_MODE, even if no change was made on
the mode parameters.
user interface. If the user only modifies timing registers (SMC_SETUP, SMC_PULSE, SMC_CYCLE registers) in
the user interface, he must validate the modification by writing the SMC_MODE, even if no change was made on
the mode parameters.
The user must not change the configuration parameters of an SMC Chip Select (Setup, Pulse, Cycle, Mode) if
accesses are performed on this CS during the modification. Any change of the Chip Select parameters, while
fetching the code from a memory connected on this CS, may lead to unpredictable behavior. The instructions used
to modify the parameters of an SMC Chip Select can be executed from the internal RAM or from a memory
connected to another CS.
accesses are performed on this CS during the modification. Any change of the Chip Select parameters, while
fetching the code from a memory connected on this CS, may lead to unpredictable behavior. The instructions used
to modify the parameters of an SMC Chip Select can be executed from the internal RAM or from a memory
connected to another CS.
A[25:2]
write cycle
(WRITE_MODE = 1)
Early Read
wait state
MCK
NRD
internal write controlling signal
external write controlling signal
(NWE)
D[7:0]
read cycle
no hold
read setup = 1
(READ_MODE = 0 or READ_MODE = 1)