Atmel Xplained Pro Evaluation Kit ATSAM4E-XPRO ATSAM4E-XPRO Data Sheet
Product codes
ATSAM4E-XPRO
SAM4E [DATASHEET]
Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14
554
28.13 Slow Clock Mode
The SMC is able to automatically apply a set of “slow clock mode” read/write waveforms when an internal signal
driven by the Power Management Controller is asserted because MCK has been turned to a very slow clock rate
(typically 32kHz clock rate). In this mode, the user-programmed waveforms are ignored and the slow clock mode
waveforms are applied. This mode is provided so as to avoid reprogramming the User Interface with appropriate
waveforms at very slow clock rate. When activated, the slow mode is active on all chip selects.
driven by the Power Management Controller is asserted because MCK has been turned to a very slow clock rate
(typically 32kHz clock rate). In this mode, the user-programmed waveforms are ignored and the slow clock mode
waveforms are applied. This mode is provided so as to avoid reprogramming the User Interface with appropriate
waveforms at very slow clock rate. When activated, the slow mode is active on all chip selects.
28.13.1 Slow Clock Mode Waveforms
illustrates the read and write operations in slow clock mode. They are valid on all chip selects.
indicates the value of read and write parameters in slow clock mode.
Figure 28-28. Read/Write Cycles in Slow Clock Mode
A[23:0]
NCS
1
MCK
NWE
1
1
NWE_CYCLE = 3
A[23:0]
MCK
NRD
NRD_CYCLE = 2
1
1
NCS
SLOW CLOCK MODE WRITE
SLOW CLOCK MODE READ
Table 28-4.
Read and Write Timing Parameters in Slow Clock Mode
Read Parameters
Duration (cycles)
Write Parameters
Duration (cycles)
NRD_SETUP
1
NWE_SETUP
1
NRD_PULSE
1
NWE_PULSE
1
NCS_RD_SETUP
0
NCS_WR_SETUP
0
NCS_RD_PULSE
2
NCS_WR_PULSE
3
NRD_CYCLE
2
NWE_CYCLE
3