Atmel Xplained Pro Evaluation Kit ATSAM4E-XPRO ATSAM4E-XPRO Data Sheet

979

SAM4E [DATASHEET]

Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14

After filtering, the quadrature signals are analyzed to extract the rotation direction and edges of the two quadrature
signals detected in order to be counted by timer/counter logic downstream.

The direction status can be directly read at anytime in the TC_QISR. The polarity of the direction flag status
depends on the configuration written in TC_BMR. INVA, INVB, INVIDX, SWAP modify the polarity of DIR flag.

Any change in rotation direction is reported in the TC_QISR and can generate an interrupt.

The direction change condition is reported as soon as two consecutive edges on a phase signal have sampled the
same value on the other phase signal and there is an edge on the other signal. The two consecutive edges of one
phase signal sampling the same value on other phase signal is not sufficient to declare a direction change, for the
reason that particulate contamination may mask one or more reflective bars on the optical or magnetic disk of the
sensor. (Refer to 

 for waveforms.)

The direction change detection is disabled when QDTRANS is set in the TC_BMR. In this case the DIR flag report
must not be used.

A quadrature error is also reported by the quadrature decoder logic via the QERR flag in the TC_QISR. This error
is reported if the time difference between two edges on PHA, PHB is lower than a predefined value. This

PHA

PHB

DIR

DIRCHG

change condition

Report Time

PHA

PHB

DIR

DIRCHG

spurious change condition (if detected in a simple way)

same phase

missing pulse