Mikroelektronika MikroE Development Kits MIKROE-1422 Data Sheet

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS™ socket. Make sure to align the 
cut in the lower-right part of the board 
with the markings on the silkscreen at the 
mikroBUS™ socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. Place 
shorter parts of the header pins in both 
soldering pad locations.

Before using your click board™, make sure 
to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

Pressure click Manual

0 100000 023730

Pressure Click

™

 is an accessory board in 

™

 form factor. It’s a compact 

and easy solution for adding pressure 
measurement to your design. It features 

 digital output pressure 

sensor. Pressure Click

™

 communicates 

with the target board microcontroller via 

™ 

SPI (MOSI, MISO, SCK, CS), 

I

2

C (SDA, SCL) and INT lines. The board 

is designed to use 3.3V power supply 
only. LED diode (GREEN) indicates the 
presence of power supply.

Pressure 

click

Pressure Click

™  

with it’s 

 IC is 

an ultra compact absolute piezoresistive 
pressure sensor capable to measure 
pressure (260-1260 mbar) or temperature 
(-40°C to 80°C) and provide a digital signal 
to main board microcontroller. All these 
features make this board ideal for indor and 
outdor navigations, altimeter or barometer 
for portable devices, weather station 
equipment, sport watches and many more.