Olimex 4.3'' LCD screen with backlight and resistive touch screen panel, compatible with A13-OLinuXino and iMX233-OLinuXino Oli A13-LCD43TS Data Sheet
Product codes
A13-LCD43TS
OLIMEX© 2012
A13-OLinuXino user's manual
6.2 SD/MMC slot
The microSD card slot is a standard 8pin connector.
The SD card can be used for booting the operating system for A13-OLinuXino. It is suggested to
have an SD card with a proper Linux/Android image especially if you have ordered a version of the
board without NAND memory.
have an SD card with a proper Linux/Android image especially if you have ordered a version of the
board without NAND memory.
We have tested a number of microSD cards on the OLinuXino boards and all of them worked fine
regardless manufacturer or capacity. However, keep in mind that some of the lower quality
microSD cards might draw too much current from the slot which might cause power-state problems.
If you suspect the microSD card is causing problems please try using another one of better quality
for better results.
regardless manufacturer or capacity. However, keep in mind that some of the lower quality
microSD cards might draw too much current from the slot which might cause power-state problems.
If you suspect the microSD card is causing problems please try using another one of better quality
for better results.
microSD card connector
Pin # Signal Name
Processor Pin #
1 DAT2/RES
113
2 SDC0_DATA3
112
3 SDC0_CMD
111
4 VDD
-
5 SDC0_SCK
110
6 VSS
-
7 SDC0_DATA0
108
8 SDC0_DATA1
107
When removing the card, please make sure that you release it from the connector by pushing and
NOT by pulling the card directly (this can damage both the connector and the microSD card).
NOT by pulling the card directly (this can damage both the connector and the microSD card).
Page 21 of 37