STMicroelectronics 250W TRANSITION-MODE PFC PRE-REGULATOR WITH L6563S EVL6563S-250W EVL6563S-250W Data Sheet
Product codes
EVL6563S-250W
AN3119
Test results and significant waveforms
Doc ID 16849 Rev 2
21/32
The event of an open-loop is demonstrated in
and
; notice the protection
intervention, latching the operation of the L6563S. As mentioned previously, to restart the
system it is necessary to recycle the input power. The connection of the startup resistors
after the rectifier bridge allows a restart, in case of latch, faster than connecting the resistor
to the bulk capacitor. In this case, to restart the operation it is necessary to wait the time
needed to discharge the bulk capacitor below the V
system it is necessary to recycle the input power. The connection of the startup resistors
after the rectifier bridge allows a restart, in case of latch, faster than connecting the resistor
to the bulk capacitor. In this case, to restart the operation it is necessary to wait the time
needed to discharge the bulk capacitor below the V
ccrestart
to reset the latch and then
resume the operation.
Figure 31.
EVL6563S-250W load transient at 115 Vac - 60 Hz - full load to no-load
CH1: PFC output voltage,
CH2: PFC_OK (pin #7),
CH3: gate drive (pin #13),
CH4: Iout
Figure 32.
EVL6563S-250W TM PFC: open-
loop at 115 Vac - 60 Hz - full load
loop at 115 Vac - 60 Hz - full load
Figure 33.
EVL6563S-250W TM PFC: open-
loop at 115 Vac - 60 Hz - full load -
long acquisition
loop at 115 Vac - 60 Hz - full load -
long acquisition
CH1: PFC output voltage
CH2: Vcc (pin #14)
CH3: gate drive (pin #13)
CH4: PWM_LATCH (pin#8)
CH1: PFC output voltage
CH2: Vcc (pin #14)
CH3: gate drive (pin #13)
CH4: PWM_LATCH (pin#8)