Olimex Open Source Hardware Electrocardiography electromyography shield for DUINOMITE, PINGUINO, MAPLE, ARDUINO like developmen SHIELD-EKG-EMG User Manual
Product codes
SHIELD-EKG-EMG
OLIMEX© 2012
SHIELD-EKG-EMG
recognized USB Serial Port (COMx) device to set x to a free port between 1 and 4
(because the monitoring software in this example can read only from COM ports 1 to
4).
(because the monitoring software in this example can read only from COM ports 1 to
4).
9. Start Arduino IDE 1.0 and open the provided by Olimex project
ShieldEkgEmgDemo.pde
ShieldEkgEmgDemo.pde
10. Set Tools -> Board -> Arduino Duemilanove w/ ATmega328
Set Tools -> Serial port -> the COM we configured our board at
11. Click Upload (→)
12. Download, install and start the software from this page:
13. It is advisable to adjust the settings in your ElecGuru program in Preferences->
Trace (waveform)… (depending how many channels/shields you use)
Trace (waveform)… (depending how many channels/shields you use)
14. Choose the COM port your OLIMEXINO is connected to from Preferences ->
Serial port… (Remember you have to set it to COM 1 to 4)
Serial port… (Remember you have to set it to COM 1 to 4)
15. You connect the electrodes to your right arm, left arm and the DLR to your right
leg
leg
16. Start monitoring, adjust the settings until you receive an image like the one shown
on the picture
on the picture
Page 13 of 20