Olimex Development board for STM32F407ZGT6 CORTEX-M4 microcontroller STM32-H407 STM32-H407 User Manual
Product codes
STM32-H407
OLIMEX© 2013
STM32-H407 user's manual
CHAPTER 3 STM32-H407 BOARD DESCRIPTION
3. Introduction to the chapter
In this chapter you will get acquainted with the main parts of the board. Note the names used on the
board differ from the names used to describe them. For the actual names check the STM32-H407
board itself.
board differ from the names used to describe them. For the actual names check the STM32-H407
board itself.
The board comes with a bag with 4 headers for the Arduino/Maple/Pinguino platform which were
left unsoldered in case you don't wish to use those environments or you don't plan on using shields.
left unsoldered in case you don't wish to use those environments or you don't plan on using shields.
There is also a bag of 4 rubber pads which can be placed in the 4 corner holes of the board. That
way the board will be safe from short-circuiting on the bottom if placed on low-resistance surface.
The placement stability of the board will also increase.
way the board will be safe from short-circuiting on the bottom if placed on low-resistance surface.
The placement stability of the board will also increase.
3.1 Layout (top view)
3.2 Layout (bottom view)
On the bottom there are three tables printed – general jumper table, boot mode jumper table, power
mode jumper table. The default positions of the tables are also shown.
mode jumper table. The default positions of the tables are also shown.
Page 9 of 28