STMicroelectronics L6563H 100 W TM PFC demonstration board EVL6563H-100W EVL6563H-100W Data Sheet
Product codes
EVL6563H-100W
Test results and significant waveforms
AN3063
10/33
Doc ID 16261 Rev 3
4
Test results and significant waveforms
4.1
Harmonic content measurement
One of the main purposes of a PFC pre-conditioner is the correction of input current
distortion, decreasing the harmonic contents below the limits of the relevant regulations.
Therefore, this demonstration board has been tested according to the European standard
EN61000-3-2 class-D and Japanese standard JEITA-MITI Class-D, at full load at both the
nominal input voltage mains.
distortion, decreasing the harmonic contents below the limits of the relevant regulations.
Therefore, this demonstration board has been tested according to the European standard
EN61000-3-2 class-D and Japanese standard JEITA-MITI Class-D, at full load at both the
nominal input voltage mains.
The circuit is able to reduce the harmonics well below the limits of both regulations from full
load down to light load (measurements are shown in
load down to light load (measurements are shown in
and
). Please note that all
measures and waveforms have been done using a Pi-filter for filtering the noise coming from
the circuit, using a 20 mH common
the circuit, using a 20 mH common
-
mode choke and two 470NF-X2 filter capacitors.
Figure 3.
EVL6563H-100W TM PFC:
compliance to EN61000-3-2
standard
compliance to EN61000-3-2
standard
Figure 4.
EVL6563H-100W TM PFC:
compliance to JEITA-MITI standard
compliance to JEITA-MITI standard
Vin = 230 Vac - 50 Hz
Pout = 100 W
THD = 2.72 %
PF = 0.982
Vin = 100 Vac - 50 Hz
Pout = 100 W
THD = 2.94 %
PF = 0.999
!-V
+DUPRQLF2UGHU>Q@
+
D
UP
RQ
LF&
X
UU
H
Q
W>
$
@
0HD VXUHGYDOXH
(1&ODVV'OLPLWV
!-V
+DUPRQLF2UGHU>Q@
+
D
UP
R
Q
LF
&
X
UUH
Q
W
>$@
0HD VXUHGYDOXH
-(,7$0,7,&ODVV'OLPL WV