STMicroelectronics Discovery kit for STM32 F030 Value line - with STM32F030R8 MCU STM32F0308-DISCO STM32F0308-DISCO Data Sheet
Product codes
STM32F0308-DISCO
ST-LINK/V2 installation and development
UM1677
DocID025326 Rev 1
4
ST-LINK/V2 installation and development
STM32F030 Discovery board includes an ST-LINK/V2 embedded debug tool interface that
is supported by the following software toolchains:
•
is supported by the following software toolchains:
•
IAR™ Embedded Workbench for ARM (EWARM) available from www.iar.com
The toolchain is installed by default in the C:\Program Files\IAR Systems\Embedded
Workbench 6.5 directory on the PC’s local hard disk.
After installing EWARM, install the ST-LINK/V2 driver by running the
ST-Link_V2_USB.exe from [IAR_INSTALL_DIRECTORY]\Embedded Workbench
6.5\arm\drivers\ST-Link \ST-Link_V2_USBdriver.exe
The toolchain is installed by default in the C:\Program Files\IAR Systems\Embedded
Workbench 6.5 directory on the PC’s local hard disk.
After installing EWARM, install the ST-LINK/V2 driver by running the
ST-Link_V2_USB.exe from [IAR_INSTALL_DIRECTORY]\Embedded Workbench
6.5\arm\drivers\ST-Link \ST-Link_V2_USBdriver.exe
•
RealView Microcontroller Development Kit (MDK-ARM) toolchain available from
www.keil.com
The toolchain is installed by default in the C:\Keil directory on the PC’s local hard disk;
the installer creates a start menu µVision4 shortcut.
When connecting the ST-LINK/V2 tool, the PC detects new hardware and asks to
install the ST-LINK_V2_USB driver. The “Found New Hardware wizard” appears and
guides you through the steps needed to install the driver from the recommended
location.
www.keil.com
The toolchain is installed by default in the C:\Keil directory on the PC’s local hard disk;
the installer creates a start menu µVision4 shortcut.
When connecting the ST-LINK/V2 tool, the PC detects new hardware and asks to
install the ST-LINK_V2_USB driver. The “Found New Hardware wizard” appears and
guides you through the steps needed to install the driver from the recommended
location.
•
Atollic TrueSTUDIO
®
STM32 available from www.atollic.com
The toolchain is installed by default in the C:\Program Files\Atollic directory on the PC’s
local hard disk.
The ST-Link_V2_USB.exe is installed automatically when installing the software
toolchain.
local hard disk.
The ST-Link_V2_USB.exe is installed automatically when installing the software
toolchain.
Note:
The embedded ST-LINK/V2 supports only SWD interface for STM32 devices.
Refer to the firmware package release notes for the version of the supporting development
toolchains.
Refer to the firmware package release notes for the version of the supporting development
toolchains.