STMicroelectronics High side driver based on L6370Q STEVAL-IFP020V1 STEVAL-IFP020V1 Data Sheet
Product codes
STEVAL-IFP020V1
Data brief
For further information contact your local STMicroelectronics sales office.
December 2011
Doc ID 022632 Rev 1
1/4
4
STEVAL-IFP020V1
PLC (for industrial automation) digital output solution using a
2.5 A single high-side smart power switch based on the L6370Q
Features
■
Single-channel topology
■
Galvanic isolation
■
2.5 A output current
■
9.5 V to 35 V supply voltage range
■
Short-circuit, overload, and thermal protections
■
Loss of ground and V
S
protections
■
Fast demagnetization of inductive loads
■
Open load, output short to V
S
detection
■
Two diagnostic outputs
■
Output status LED driver
■
EMC immunity against burst, surge, and ESD
■
RoHS compliant
Description
The STEVAL-IFP020V1 demonstration board is
based on the L6370Q, a single-channel high-side
driver chip intended for driving resistive, inductive
or capacitive loads in an industrial environment. It
provides an embedded fast demagnetization
feature for inductive load switch-off.
based on the L6370Q, a single-channel high-side
driver chip intended for driving resistive, inductive
or capacitive loads in an industrial environment. It
provides an embedded fast demagnetization
feature for inductive load switch-off.
The device evaluates load disconnection (during
channel on-state), output short to V
channel on-state), output short to V
CC
or GND,
overtemperature, undervoltage of supply voltage,
and provides feedback to a control unit.
and provides feedback to a control unit.
Integrating an extensive set of electrical
protections makes the application safe and
reliable for use in harsh conditions.
protections makes the application safe and
reliable for use in harsh conditions.
The STEVAL-IFP020V1 demonstration board is
an example of application design using the
L6370Q. It is used to guide the designer in
choosing external components for applications
while providing an appropriate PCB design.
an example of application design using the
L6370Q. It is used to guide the designer in
choosing external components for applications
while providing an appropriate PCB design.
STEVAL-IFP020V1