ParkZone ArtiZan PKZ6975 Data Sheet

1.   Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.

2.   Install the left and right horizontal tails (B) onto the fuselage as shown. 

Ensure the control horn faces down.

3.   Apply 4 pieces of tape (C) to the fuselage mounts (one on the top and bot-

tom of each half of the horizontal tail).

4.   Attach the clevis to the elevator control horn (see instructions for clevis 

connection).

When needed, disassemble in reverse order.

Tip: Turn the clevis on the linkage to change the length of the linkage 
between the servo arm and the control horn.

•  Pull the tube from the clevis to the linkage.
•  Carefully spread the clevis, then insert the clevis pin into the desired 

hole in the control horn. 

•  Move the tube to hold the clevis on the control horn.

After binding a transmitter to the aircraft receiver, set the trims and 
sub-trims to 0, then adjust the clevises to center the control surfaces.

Factory Settings

Horns

Arms

More control throw

Less control throw

The table to the right shows the factory settings for the control horns and servo 
arms. Fly the aircraft at factory settings before making changes. 

After fl ying, you may choose to adjust the linkage positions for the 
desired control response. See the table below.