ParkZone RTB 1300 mm PKZ6880 Data Sheet

1. Install the vortex generators (A) in the wing channels (B) by using double-

sided tape (C). 

CAUTION: DO NOT crush or otherwise damage the wiring when 

attaching the wing to the fuselage.

2. Slide the wing tube (D) in the hole in the left wing.

3. Slide the other end of the wing tube into the hole in the right wing until

both wings meet.

4. Install the wing cover (E) on the top of the wing, aligning the 4 holes as

shown.

1. Connect the aileron servos from the wings to the Y-harness connectors in

the fuselage. The left and right aileron servos can be connected to either
side of the Y-harness.

IMPORTANT: Correct operation of the AS3X system requires connection of  
both ailerons to the included Y-harness and the AILE channel of the receiver.

Tip: A servo extension (PKZ5403, sold separately) may be installed in the re-
ceiver bind port so binding may be done through the battery door in the bottom 
of the aircraft.

2.  Attach the assembled wing and wing cover (E) to the fuselage using 4

screws (F). 

3.  Attach the left (G) and right (H) struts (marked L and R) under the wing and

fuselage using 6 screws (I).

IMPORTANT: On the wings, tighten the 4 screws in the middle of the strut slots 
so the wings are not pulled down (Fig J).

Disassemble in reverse order.

3 X 12mm (4)

2.5 X 10mm (6)

Bag C

Bag C

Fig. J