Reely 4WD ARR QCO1E4W000EV60N01 Data Sheet

Product codes
QCO1E4W000EV60N01
Page of 100
48
The vehicle doesn’t drive in a straight line correctly
• Set straight driving at the transmitter using the respective trimming control for the steering function.
• Check the steering rods or wheel alignment setting.
• Did your car have an accident? If so, check the vehicle for any defective or broken parts and replace them.
Steering or driving motions opposite to movement of steering wheel and transmitter throttle/brake lever
• Check the settings of the reverse switch for steering and drive at the transmitter.
• If the motor was disconnected from and reconnected to the speed controller, the two cables may have been swapped.
The steering is not functioning or is functioning incorrectly, steering deflection at the vehicle insufficient
• If the transmitter offers dual rate settings, check these settings (observe transmitter’s operating instructions). If the
dual rate setting is too low, the steering servo will no longer react.
• Check the steering mechanics for loose parts; e.g. check if the servo arm is properly attached to the servo.


12. Disposal
Electronic devices must not be disposed of in the domestic waste!
At the end of its service life, dispose of the product according to the relevant statutory regulations.