ECX Brushed 1:10 RC model car Electric Short co ECX03026 User Manual

TORMENT

®

The gear mesh has already been set at the factory. Setting the 
gear mesh is only necessary when changing motors or gears.
You must remove the vehicle’s gear cover (A) to make this 
adjustment. 
Proper gear mesh (how the gear teeth meet) is important to the 
performance of the vehicle. When the gear mesh is too loose, the 
spur gear could be damaged by the pinion gear of the motor. If 
the mesh is too tight, speed could be limited and the motor and 
ESC will overheat. 
Set the gear mesh by following these simple steps:
1. Loosen the 2 motor screws (B).
2. Put a small piece of paper (C) between the pinion and spur 

gears.

3. Push the gears together while tightening the motor screws.
4. Rotate the gears to remove the paper. The gearing should 

move a small amount.

5. Reinstall the gear cover.

For correct operation, Channels 1 and 2
must be used as shown in the wiring diagram. 
The motor can be disconnected from the ESC 
at the connectors in the wiring.

A

DYN1172

Motor 

B

DYN1050EC

Battery 7.2V

C

SPMS603

Waterproof Steering 

Servo

D

SPMSR201

Receiver

E

DYNS2210

Waterproof Electronic 

Speed Control (ESC)

F

Channel 1

G

Channel 2

Programming: The ESC comes with two jumpers pre-installed in 
the REV: ON and BATT: Ni-MH confi gurations.
To disable reverse or change battery type to Li-Po, disconnect the 
jumper from the default port and connect it to the desired port. 
Power off the ESC, then power it back on.
If the jumpers are lost or not installed, the ESC will default to 
REV: ON and BATT: Li-Po.

Stop

OFF

Forward

Blinks

Forward (full speed)

Solid

Reverse

Blinks

Brake

Blinks

Brake (full brake)

Solid

Ni-MH/Ni-Cd Battery

1 Short Beep

2S Li-Po Battery

2 Short Beeps

ESC Ready

1 Long Beep

Battery Low Voltage

Blinks

Overheat

Blinks

LED