Blade 200 SR X BNF BLH2080 Data Sheet

Product codes

BLH2080

Transmitter and Receiver Binding

If you purchased an RTF model, the transmitter is bound to the model at the factory.

To bind or re-bind your Nano CP X to your chosen transmitter, please follow the directions below:

Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique
Identiﬁ er) code of a single speciﬁ c transmitter. You need to ‘bind’ your chosen Spektrum

™

DSM2

DSMX

technol-

ogy equipped aircraft transmitter to the receiver for proper operation.

NOTICE: Use the Non-Computer Radio binding instructions if you are using a DX4e or DX5e transmitter
with the Nano CP X BNF.

Binding Procedure for Non-Computer Radio (DX4e, DX5e)

1. Disconnect the ﬂ ight battery from the helicopter.

2. Power off the transmitter and move all switches to the 0 position.

3. Connect the ﬂ ight battery to the helicopter. The 3-in-1 Control unit LED ﬂ ashes after 5 seconds.

4. Push the trainer switch or button while powering on the transmitter.

5. Move the rudder control stick to full left after the transmitter LED lights ﬂ ash twice.

6. Release the trainer switch/button. Continue to hold the rudder control stick to full left until the blue LED

on the 3-in-1 control unit is solid.

7. Release the rudder control stick.

8. Push the trainer switch/button. The blue LED on the 3-in-1 control unit ﬂ ashes to conﬁ rm the helicopter

is in non-computer mode.

9. Disconnect the ﬂ ight battery and power the transmitter off.

Binding Procedure for Computer Radios:

1. Disconnect the ﬂ ight battery from the helicopter.

2. Power off the transmitter and move all switches to the 0 position.

3. Connect the ﬂ ight battery to the helicopter. The 3-in-1 Control unit LED ﬂ ashes after 5 seconds.

4. Push the bind switch/button while powering on the transmitter.

5. After 2–3 seconds, release the bind switch/button.

6. Move the rudder control stick to full right. Continue to hold the rudder control stick to full right until the

blue LED on the 3-in-1 control unit is solid.

7. Release the rudder control stick.

8. Disconnect the ﬂ ight battery and power the transmitter off.

NOTICE: The throttle will not arm if the transmitter’s throttle control is not put at the lowest position and the stunt
mode switch is not in the 0 position.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other
instructions. If needed, contact the appropriate Horizon Product Support ofﬁ ce.

For a list of compatible DSM2/DSMX transmitters, please visit www.bindnﬂ y.com.

NOTICE: If the swashplate moves up and down when the trainer switch is moved, the helicopter is in computer
transmitter mode; repeat binding procedure.