Blade 200 SR X RTF BLH2000 Data Sheet

Elevator down

Elevator up

Aileron left

Aileron right

Test the controls prior to the fi rst fl ight to ensure the servos, linkages and parts operate correctly. Ensure the throttle is in 
the low position when doing the control tests.

Place the helicopter outdoors on a clean, fl at and level surface (concrete or asphalt) free of obstructions. Always stay clear 
of moving rotor blades.

CAUTION: Keep pets and other animals away from the helicopter. Animals may injure themselves if they
attack or run toward the helicopter.

1. The motor beeps twice when the helicopter’s ESC arms properly. Before you continue, confi rm that throttle is at full 

low position.

WARNING: Stay at least 30 feet (10 meters) away from the helicopter when the motor is running.
Do not attempt to fl y the helicopter at this time.

2. Ensure the throttle is lowered completely. Ensure the transmitter is still setup as described in the Transmitter Setup 

Table. Slowly increase the throttle until the blades begin to spin. The main blades spin clockwise when viewing the 
helicopter from the top. The tail rotor blades spin counterclockwise when viewing the helicopter from the right-hand 
side.

NOTICE: If the main rotor blades are spinning counterclockwise, reduce the throttle to low immediately. Disconnect the 
battery from the helicopter and reverse any two motor wire connections to the ESC and repeat the motor control test.