Carson 01:12 Functional model Mercedes Benz Unimog U300 with remote control (500907170) 500907170 Data Sheet

Product codes

500907170

CARSON Mercedes Benz UNIMOG 50 090 7170

o. Troubleshooting

n. Shut down

m. Lights

Follow reverse procedure to shut down.

1. Turn off the model.

2. Turn off the transmitter.

• Never touch or hinder rotating tires.

• Never run RC model in the rain or let run over puddles, as water

may cause trouble with the RC model.

• The motor and battery may become hot during operation. Take

care when you handle them.

• Remove the batteries from the model and the transmitter when

they are not in use.

Cautions when handling batteries/rechargeable
batteries

Only use

the supplied battery for the RC model and 8x AA

rechargeable/non-rechargeable batteries for the transmitter.

• Do not recharge abattery that is still warm from use as it may

damage the battery. Allow the battery to cool off prior to
recharging.

• Remove transmitter battery when not using it for a long term as it

may leak and damage the transmitter, when left for a long period.

• Never incinerate used batteries, as they can explode causing

serious accidents.

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the model before

being charged.

• Rechargeable batteries are only to be charged under adult

supervision.

• Batteries are to be inserted with the correct polarity.

• Exhausted batteries are to be removed from the model.

• Please check the electronics, cable, body and other parts regularly

for damage.

• Only use the charger supplied!

Problem

Cause

Remedy

Model does not move

Transmitter switch and/or model switch is/are off

Switch on

Weak or no rechargeable batterie/battery in the
model

Install charged rechargeable batterie/battery

Heat protector has stopped car due to excess heat

Turn off receiver switch. Let RC model cool down for
approximately 30 minutes.

Weak or no batteries in transmitter or model

Install charged or fresh batteries

No control

The lights can be switched on or off as required. The switch is on the
top right of the transmitter.