Uhlenbrock 65100 Intellibox II DCC System 65100 Data Sheet

 

The keys [f0] [f1] [f2] [f3] [f4] 
These keys switch locomotive special functions such as Light, Special lighting, Horn or 
Smoke unit. 

The [lok]-key 
starts the selection of the wanted locomotive for respective control desk. 

If a vehicle is already selected then pressing the [lok]-key twice will enter the Loco Menu. 
Here you can build a Multi-traction, assign locomotive to a hand controller or edit 
locomotive data. 

The Throttle knob 
The throttle knob is used to change the locomotive speed and direction. The rotating 
throttle without end stop on the Intellibox II automatically restores the saved speed when a 
new locomotive is selected. 

The Display 
The large backlit LCD display always gives you an exact overview of the running status.

 

 

 

 

 

 

 

 

 

 

The display of the used locomotive, running speed and direction of actually controlled 
vehicles are shown separately for each controller. The display keys at the sides are 
assigned with loco special functions. If the controlled locomotive has more than 4 special 
functions the triangular scroll keys, top and bottom can be used scroll through further 
functions. If it is possible to scroll up or down the corresponding scroll key is lit up. 

The scrollbar diagrammatically shows at which point in the selection range the display keys 
are.

 

In a digital control system an individual locomotive is selected by an address.  This is a 
sequence of digit, which are installed in the individual locomotive decoder for identification. 

Each decoder is set to its own address so that the locomotive can be addressed by this 
particular address. 

In order to simplify locomotive selection each locomotive can be assigned a name. If the 
assignment is done once the Intellibox II saves it permanently.

 

In every new locomotive selection it can be selected from a list by name.