Mc Crypt DJ Mixer SA-101U 304465 Data Sheet

The MASTER LEVEL indicator (4) shows the level of the output signal.
The level indicators of channels CH-1 to CH-4 show the input levels of the respective channels.

The level on the indicators should not exceed 0db continuously as otherwise the music signal can be
distorted. Signal peaks that cause the indicator to briefly light up above 0db do not pose a problem.

• Set the volume of the connected amplifier to minimum.

• Turn the TRIM control (3) to the minimum position.

• Move the channel fader (8) and the MASTER fader (9) to the minimum position as well.

• Use the input selection switches (3) to select the desired channel input.

• Start the connected playback device, e.g. a CD player. If this device has a volume control, set the volume to about

75% of the maximum level.

• Slide the respective channel fader (8) all the way to the top.

• Use the TRIM control (3) of the active channel to adjust the input level. The signal level is shown by the level

indicator of the corresponding channel. It should not exceed 0db.

• Push up the MASTER fader (9) until the maximum level is shown on the MASTER LEVEL indicator. 0db should

not be exceeded here either.

• Now set the desired maximum volume using the volume control on the amplifier. Make sure that the sound is not

distorted.

• Use controls HI/MID/LOW (3) to change the sound characteristics of the respective channel.

• Use the MASTER BALANCE control (13) to set the volume balance between the left and the right master channel.

• Repeat the setting for all mixer channels. All channels should be set to about the same volume so that there are

no great differences in volume between the channels when crossfading. Otherwise you would have to readjust
the output signal.

• After you have made these settings, only use the MASTER fader (9) when you want to change the playback

volume.