Vivanco Pre-Amplifier Microphone, Black 30339 Data Sheet

5

Microphone Preamplifier 
Input voltage: 

12V

Signal input:

2 x 6,35mm – Stereo/Mono

Signal output:

2 x Cinch

Power supply 
Input voltage: 

100-240V~ 50-60Hz, Euro plug

Output voltage:

12V

Output current:

100mA

Stand-by consumption:  

<0,3W

Operating temperature:

5...35°C

Hereby Vivanco GmbH declares that MA 225  is in conformity with the fundamental requirements
and other relevant regulations of the directive 2004/108/EU. 

Disposal of the device
This device may not be disposed along with household waste. Please hand it over to a collection
point for electrical devices of your area or your district. Thus it will be guaranteed that the old
devices are recycled properly and economically and potential environmental and health hazards
are avoided.

The packing should be supplied to re-use. Please do not throw it into household waste and
handle it in conformity with local disposal rules. 

GB

Bad or 
no reproduction

Preamplifier is not connected with
a current supply  

Microphone or reproduction 
device (for example mixing desk,
amplifier or PC) is not switched on 

Cable connection broken

The amplification set on the 
preamplifier does not fit to the 
microphone  

Volume on the reproduction device
(for example mixing desk, amplifier
or PC) is switched off or too low 

Ensure power supply

Switch on all connected 
devices 

Check if all the plug
connections are plugged in
properly

New setting of the 
preamplification

Increase volume 

BDA 30339_Layout 1  01.07.11  09:42  Seite 5