Transmotec V Linear Actuator, 200mm Stroke, 1200N, 7.5mm/s, DLA-24-40-A-200-POT-IP65 16024264CR Data Sheet

 

KG

KG

Load

Side Load

Transmotec

The load should be centered on the operating direction

Side  load  is  NOT  good  for  the  actuator.  In  case  the              

actuator rod is exposed to side load the service life time 
will be reduced

.

●
●
●
● 

Load force up to 1000N
Static force 2300N
Operating temperature -26°C~+65°C
Duty cycle 25% (25% on / 75% off) 
2.5 minutes continuous operation followed by 7.5 minutes off

The actuator will extend when the red wire connects to plus and black wire to negative, reverse them for retraction.
Make sure the actuator is not connected electrically when installed. 
Make sure you use the correct DC voltage.
Actuator force must not be over loaded. Please refer to the model number and it’s force specification. 
To avoid over load disconnect the actuator if the current exceed it’s maximum rating.
The actuator have integrated limit switches that will stop the rod when it reach it’s end position of extraction or retraction.
In order to retract or extract again the supply voltage polarity must be reverted.

kg

= Limit switch

 

KG

KG

Load

Side Load

kg

© Copyright Transmotec

MODEL NO. DESIGNATIONS

DLA

12

20

A

200

POT-IP65

Type

Voltage

12V DC
24V DC

Gear Ratio

10:1
40:1

ACME
(screw 

standard)

Stroke

50mm

100mm

200mm

300mm

Potentiometer Sensor 

and IP-Class 65

 (Exact)

10.9:1
42.8:1

5:1 10:1

30:1

40:1

20:1

5:1

10:1

30:1

40:1

20:1

Max. Load

Rated Load