Drive System Europe 24V Linear Actuator, 300mm Stroke, 250N, 29mm/s, 12399 12399 Data Sheet
Product codes
12399
© Copyright by Drive-System Europe Ltd. Stand: 20.02.2012
Dimension
Linear actuator
Length
Mass in mm
Stroke ± 3mm
50
100
150
200
250
300
DSZY1 - type standard
A
158
209
260
311
362
413
B
208
309
410
511
612
713
Mounting instruction
Please make sure, that load is not bigger than shown in the diagram speed/load. If overload is possible in the application,
please use a separate current control to switch off at too high current ( = too high load ). Nominal current, depending on
ratio, is shown in the diagram current / load.
Please use the right voltage supply as it is shown on the actuator. For extending the piston rod connect the red cable with
plus and the black cable with minus. Movement is stopped automatically at the end of the stroke. For moving back,
reverse the polarity (change plus and minus). Endswitches are not adjustable by themselves.
Load should be centered in moving direction, shear forces should be avoid because of shortening the lifetime. Big shear
forces can destroy the actuator! Be carefull.
please use a separate current control to switch off at too high current ( = too high load ). Nominal current, depending on
ratio, is shown in the diagram current / load.
Please use the right voltage supply as it is shown on the actuator. For extending the piston rod connect the red cable with
plus and the black cable with minus. Movement is stopped automatically at the end of the stroke. For moving back,
reverse the polarity (change plus and minus). Endswitches are not adjustable by themselves.
Load should be centered in moving direction, shear forces should be avoid because of shortening the lifetime. Big shear
forces can destroy the actuator! Be carefull.
Drive-System Europe Ltd.
www.drive-system.com
sales@drive-system.com