Phoenix Contact 2701030 NLC-050-024D-06I-04QTN-00A nanoLine Base Unit 24ßV/DC / NPN 2701030 Data Sheet
Product codes
2701030
nanoNavigator
6-4
PHOENIX CONTACT
2373_en_B
4.
With a nanoLC Memory Module attached to a USB port on the PC and the special USB
driver installed, select the “COM” port to use for communication to the Memory Module.
Once installed, upload or download projects from or to the Memory Module (see
6.2
Verifying a Project
At any time, it is possible to verify that the project is error-free and consistent with the
attached (or configured) nanoLC (see “Configuring nanoNavigator” on page 3-5) by
selecting the “nanoLC... Verify Program” menu. This opens the “Project Information...
Messages” tab.
Figure 6-2
The “Project Information... Messages” tab
If the verification process identifies errors, check that the configuration matches the nanoLC
intended for project execution. If there are errors identified in a flow chart, double-click the
error message to display the flow chart that has the error. The error message identifies the
flow chart, cell in the flow chart, type of block, and error cause. With this information, find
and correct any problems encountered.