ConiuGo 700100140 Data Sheet
27
Because of the RF-radiation of the GSM unit the modem has to
be used with a suitable GSM antenna for the RF band, depend-
ing on the type of the chosen GSM network). The antenna cable
has to be free from any damages.
4. Description of the modem
The modem is a GSM modem for data-, fax- and SMS- transfer in GSM networks.
From the moment the modem is booked into the provider’s network the device be-
haves like a standard modem or a fax modem. The configuration of the system is
From the moment the modem is booked into the provider’s network the device be-
haves like a standard modem or a fax modem. The configuration of the system is
carried out via the V.24 serial port. For programming the standard AT-commands
according to ETSI-standards (ETSI 07.07 or ETSI 07.05) are used. The modem is
dedicated to applications in GSM 900 & 1800 MHz networks or 850 MHz and 1900
MHz networks (depends on your order). The modem use a Bluetooth connection to
communicate with the PC.
5. Installation of the modem
The modem must be installed only in dry places. The allowed range of temperature
is
–20 to +55 °C. The common regulations for electrical installations have to be re-
garded.
The modem is allowed to be run according to the following conditions:
Ambient temperature:
–20 to +55 °C
Indoor use only, max. 70% RH
SIM-card with appropriate service subscription (e.g. for data transmission:
subscription for data transmission).
For the programming of the modem a serial cable is necessary that has a D
Sub 9 plug (m). The cable is connected to a computer (PC) that runs any
given terminal software. ConiuGo® recommends the use of the software
CommLite® (enclosed on CD).
Recommend interface settings: 8N1 on 19.200 baud.