ConiuGo 700100140 Data Sheet
35
In the future you have this connection as a icon on your desktop. To start
the connection make a double click on it.
9.6 Hang up a GPRS connection
The hang up of a existing connection could be realized from the same
GPRS Manager window.
10. First modem settings
The configuration of the modem is done with a terminal software. ConiuGo GmbH
recom
mends the use of CommLite®. After sending “AT” the modem should send
back “OK“. Go ahead to set the modem parameters and check the modem settings
as follows:
as follows:
Init-String
After an “OK”-response from the modem put in the following Init-String:
AT&F&C1&D2S0=2E0V1
After an “OK”-response from the modem put in the following Init-String:
AT&F&C1&D2S0=2E0V1
F
Enables basic settings.
C1
DCD signal is „on“, when data carrier or GPRS connection are detected
(DCD = data carrier detect)
DCD signal is „on“, when data carrier or GPRS connection are detected
(DCD = data carrier detect)
&D2
If DTR changes from „on“ to „off“, modem disconnects and enteres com-
mand mode (DTR = data terminal ready)
If DTR changes from „on“ to „off“, modem disconnects and enteres com-
mand mode (DTR = data terminal ready)
S0=2
Modem accepts incoming call after 2 „ring“.
Modem accepts incoming call after 2 „ring“.