Bourns ESE protection kit SMT 20 Parts PN-DESIGNKIT-30 Data Sheet
Product codes
PN-DESIGNKIT-30
Li-ion Battery Controller Protection
Overcurrent and ESD Protection
Solution Products
MF-SVS210
CG0603MLA-5.5ME
Battery
Controller
IC
Battery +
Battery -
Control
Battery -
Control
Signal Ground
Battery
Connector
Shield
Ground
Asia-Pacific:
Tel +886-2 256 241 17
Fax +886-2 256 241 16
Bourns® PortNote® solutions provide protection
recommendations for typical port threats.
For more information, go to:
www.bourns.com
or email: protection@bourns.com
Americas:
Tel +1-951 781-5500
Fax +1-951 781-5700
Europe:
Tel +41-(0)41 768 55 55
Fax +41-(0)41 768 55 10
Compliance
IEC 61000-4-2 ESD Level 4
Alternate Recommendations
• 1 SinglFuse™ Thin Film Chip Fuse:
(ex. SF-0603F500)
(ex. SF-0603F500)
Benefit
This solution provides full protection to battery
pack applications within rated limits.
pack applications within rated limits.
Objective
This solution provides protection for the
battery against an overcurrent condition, as
well as ESD protection for the control chip.
Because of a hot-pluggable interface, it may
require protection against ESD, short circuits
and faulty equipment.
battery against an overcurrent condition, as
well as ESD protection for the control chip.
Because of a hot-pluggable interface, it may
require protection against ESD, short circuits
and faulty equipment.
Solution
1 Multifuse® PPTC Resettable Fuse:
MF Strap type (ex. MF-SVS210-0)
3 ChipGuard® ESD Suppressors:
CG0603MLA-5.5ME
MF Strap type (ex. MF-SVS210-0)
3 ChipGuard® ESD Suppressors:
CG0603MLA-5.5ME
COPYRIGHT© 2012 • BOURNS, INC. • 6/12 • WAG • e/CPK1111 • “PortNote” is a registered service mark of Bourns, Inc.
“SinglFuse” is a trademark of Bourns, Inc.
“Bourns”, “Multifuse” and “ChipGuard” are registered trademarks of Bourns, Inc. in the U.S. and other countries.
“SinglFuse” is a trademark of Bourns, Inc.
“Bourns”, “Multifuse” and “ChipGuard” are registered trademarks of Bourns, Inc. in the U.S. and other countries.
Design Kit
The schematic above illustrates the application protection and does not constitute the complete circuit design.
Customers should verify actual device performance in their specific applications.