Nkk Switches AS13AH AS13AH AS13AH Data Sheet

H

Indicators

Accessories

Supplement

Tactiles

Keylocks

Rotaries

Pushbuttons

Illuminated PB

Slides

Programmable

Rockers

Touch

Tilt

 

Toggles

  0.4VA maximum @ 28V AC/DC maximum 

 

  (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)

 

  Note:  Find additional explanation of operating range in Supplement section.

Contact Resistance:   50 milliohms maximum 

Insulation Resistance:  500 megohms minimum @ 500V DC

Dielectric Strength:  500V AC minimum for 1 minute minimum

Mechanical Life:  50,000 operations minimum 

Electrical Life:  50,000 operations minimum

Nominal Operating Force:  2.55N 

Contact Timing:  Nonshorting (break-before-make)

Travel:    Pretravel: .082” (2.1mm); Overtravel: .016” (0.4mm); Total Travel: .098” (2.5mm)  

Actuator:  Glass fiber reinforced polyamide 

 

Upper Case Housing:  Carbon blended polyacetal (antistatic) 

 

Lower Case Housing:  Glass fiber reinforced polyamide

 

Support Bracket:  Tin plated phosphor bronze

Movable Contact:  Phosphor bronze with gold plating

Stationary Contacts:  Brass with gold plating

Terminals:  Brass with gold plating

 Operating Temperature Range:  –30°C through +85°C (–22°F through +185°F)
 

Humidity:   90 ~ 95% humidity for 192 hours @ 40°C (104°F)

Vibration:  10 ~ 60Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range  

 

  & returning in 5 minutes; 3 right angled directions for 30 minutes

Shock:  50G (490m/s

2

) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)

Soldering:   Wave Soldering Recommended.  See Profile A in Supplement section. 

 

  Manual Soldering:  for single pole see Profile B in Supplement section; for double pole see Profile A.

Cleaning:  These devices are not process sealed.  Hand clean locally using alcohol based solution.  

  The A Series slides have not been tested for UL recognition or CSA certification. 

 

  These switches are designed for use in a low-voltage, low-current, logic-level circuit. 

 

  When used as intended in a logic-level circuit, the results do not produce hazardous energy. 

General 

Specifications