Solar Trend 03091 Data Sheet
User manual
Power set 90W - 230V item no. 03091
Distribution by Süd Solar GmbH, Max-Eyth-Str. 6, 71732 Tamm (Germany)
Copyright © Süd Solar GmbH, 2011, subject to modifications.
www.sued-solar.de
Copyright © Süd Solar GmbH, 2011, subject to modifications.
www.sued-solar.de
REV-2-19-01-12
1. Introduction
Dear customer. Thank you for purchasing one of our products.
This product corresponds to the applicable European directives and National regulations.
Conformity has been proven. Relevant declarations and documents are deposited at the manufacturer.
2. Safety note
This product corresponds to the applicable European directives and National regulations.
Conformity has been proven. Relevant declarations and documents are deposited at the manufacturer.
2. Safety note
Failure to observe these instructions will render the warranty void. We assume no liability for
consequential damages!
We will assume no liability for material damage or personal injury resulting from inappropriate handling
or non-compliance with the safety precautions. In such cases, any warranty shall be void. For safety reasons (CE), unauthorised
alterations or changes to the product are not permitted. This product is not a toy. Keep out of children's reach.
consequential damages!
We will assume no liability for material damage or personal injury resulting from inappropriate handling
or non-compliance with the safety precautions. In such cases, any warranty shall be void. For safety reasons (CE), unauthorised
alterations or changes to the product are not permitted. This product is not a toy. Keep out of children's reach.
3. Application, setup and connection as directed
The product is designed for outdoor use and intended for gaining solar power.
Please make sure that the polarity is correct during setup.
Please refer to the identification markings PLUS (+) and MINUS (-)!
The following sketch illustrates the connection of all components to the charge / discharge regulator (item no. 03155):
Please make sure that the polarity is correct during setup.
Please refer to the identification markings PLUS (+) and MINUS (-)!
The following sketch illustrates the connection of all components to the charge / discharge regulator (item no. 03155):
4. Continuation initial start-up
6. Purchase a suitable 12V rechargeable battery with sufficient capacity (Ah) to allow a greater energy storage. A rechargeable
battery with approx. 107Ah is recommendable. Special solar batteries are offered under www.sued-solar.de.
7. Do not switch on the appliances (load) until the solar module has charged the 12V battery sufficiently.
8. Connect the voltage converter (12V / 230V) directly to the 12V battery (see separate instructions for voltage converter).
4. Initial start-up
1. Carefully unpack all parts.
2. Position the three solar modules (item no.
03150) in a suitable place exposed to direct
sunlight. All cables must be laid accurately and
safely.
sunlight. All cables must be laid accurately and
safely.
3. Connect the battery connection cable (item no.
80083) of a 12V battery (such a rechargeable
battery is not included in the delivery) to the
two middle connections. Connect the lead
marked with PLUS (+) to "B+" and the lead
marked with MINUS (-) to "B-".
battery is not included in the delivery) to the
two middle connections. Connect the lead
marked with PLUS (+) to "B+" and the lead
marked with MINUS (-) to "B-".
4. Use the 10cm cable with clamp (item no.
80084) to connect the three solar modules to
the two left connections. Then connect the
lead marked with PLUS (+) to "S+" and the
lead marked with MINUS (-) to "S-".
the two left connections. Then connect the
lead marked with PLUS (+) to "S+" and the
lead marked with MINUS (-) to "S-".
5. Connect the appliances (load), e. g. LED flash
light (item no. 03100) to the two right
connections. Then connect the lead marked
with PLUS (+) to "L+" and the lead marked
with MINUS (-) to "L-".
connections. Then connect the lead marked
with PLUS (+) to "L+" and the lead marked
with MINUS (-) to "L-".