TP-LINK JetStream TL-SG3216 TL-SG3216 Data Sheet
Product codes
TL-SG3216
no gvrp timer [ leaveall | join | leave ]
Parameter
leaveall | join | leave —— They are the three timers: leaveall, join and leave.
Once the LeaveAll Timer is set, the port with GVRP enabled can send a LeaveAll
message after the timer times out, so that other GARP ports can re-register all
the attribute information. After that, the LeaveAll timer will start to begin a new
cycle. To guarantee the transmission of the Join messages, a GARP port sends
each Join message two times. The Join Timer is used to define the interval
between the two sending operations of each Join message. Once the Leave
Timer is set, the GARP port receiving a Leave message will start its Leave timer,
and deregister the attribute information if it does not receive a Join message
again before the timer times out.
Once the LeaveAll Timer is set, the port with GVRP enabled can send a LeaveAll
message after the timer times out, so that other GARP ports can re-register all
the attribute information. After that, the LeaveAll timer will start to begin a new
cycle. To guarantee the transmission of the Join messages, a GARP port sends
each Join message two times. The Join Timer is used to define the interval
between the two sending operations of each Join message. Once the Leave
Timer is set, the GARP port receiving a Leave message will start its Leave timer,
and deregister the attribute information if it does not receive a Join message
again before the timer times out.
value ——The value of the timer. The LeaveAll Timer ranges from 1000 to 30000
centiseconds and the default value is 1000. The Join Timer ranges from 20 to
1000 centiseconds and the default value is 20. The Leave Timer ranges from 60
to 3000 centiseconds and the default value is 60.
centiseconds and the default value is 1000. The Join Timer ranges from 20 to
1000 centiseconds and the default value is 20. The Leave Timer ranges from 60
to 3000 centiseconds and the default value is 60.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
gigabitEthernet)
Example
Set the GARP leaveall timer of port 6 to 2000 centiseconds and restore to the
join timer of it to the default value:
join timer of it to the default value:
TL-SG3424(config)# interface gigabitEthernet 1/0/6
TL-SG3424(config-if)# gvrp timer leaveall 2000
TL-SG3424(config-if)# no gvrp timer join
show gvrp global
Description
The
show gvrp global command is used to display the global GVRP status.
Syntax
show gvrp global
Command Mode
Privileged EXEC Mode and Any Configuration Mode
44