TP-LINK 16-Port Gigabit Web Smart Switch with 2 Combo SFP Slots TL-SG2216WEB Data Sheet
Product codes
TL-SG2216WEB
05
Gigabit Smart Switch
LED
Status
Indication
10/100/
1000Mbps
1000Mbps
Green
On
A 1000Mbps device is connected to the corresponding
port, but no activity
Flashing Data is being transmitted or received
Yellow
On
A 10/100Mbps device is connected to the corresponding
port, but no activity
Flashing Data is being transmitted or received
Off
No device is connected to the corresponding port
10/100/1000Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or
1000Mbps. Each has a corresponding 1000Mbps LED.
1000Mbps. Each has a corresponding 1000Mbps LED.
SFP Port
Designed to install the SFP module. TL-SG2452 features 4 individual SFP ports.
Reset
Press this button for five seconds or above to reset the software setting back to
factory default settings.
factory default settings.
Port Feature
Model
10/100/1000Mbps RJ45 Port
SFP Port
TL-SG2216
16
2
TL-SG2424
24
4
TL-SG2424P
24
4
TL-SG2452
48
4
Note: For TL-SG2216/TL-SG2424/TL-SG2424P, when using the SFP port with a
100M module or a gigabit module, you need to log on to the GUI (Graphical User
Interface) of the Switch and configure its corresponding Speed and Duplex mode on
Switching→Port→Port Config page. For 100M module, please select 100MFD
while select 1000MFD for gigabit module. By default, the Speed and Duplex mode of
SFP port is 1000MFD. TL-SG2452 supports 1000M SFP module connection only.
100M module or a gigabit module, you need to log on to the GUI (Graphical User
Interface) of the Switch and configure its corresponding Speed and Duplex mode on
Switching→Port→Port Config page. For 100M module, please select 100MFD
while select 1000MFD for gigabit module. By default, the Speed and Duplex mode of
SFP port is 1000MFD. TL-SG2452 supports 1000M SFP module connection only.
Rear Panel
The rear panel of TL-SG2216 is shown as the following figure.
Grounding Terminal
Power Socket
Rear Panel
Figure 1-5
of
TL-SG2216
Introduction